I'm trying to program a few Insteon switches in X10 mode, but I'm having a heck of a problem. I followed the instruction here:
1) Set SwtichLinc Relay to linking mode by pressing ahd holding the Paddle Top for 10 seconds until the top LED in the LED bar begins blinking slowly and the controlled light flashes
2) Using an X10 controller, send the following sequence three times in succession: x10 primary address followed by the ON command
3) Once SwitchLinc Relay has received the preceding sequence three times, SwitchLinc will confirm that it has its Primary X10 Address by blinking the top LED in its LED bar and flashing the light that it's wired to
Just wanted to make sure, for (1) if I press and hold the paddle top for 10 seconds, top LED blinks, and the bottom LED blinks rapidly. Not sure what the "controlled light flashes" refers to - bottom LED?
For (3), the light never flashes and after 3 x10 commands, the paddle LED continues to flash. I'm using a Maxi controller and I can control other lights no problem.
Thanks for your assistance.
1) Set SwtichLinc Relay to linking mode by pressing ahd holding the Paddle Top for 10 seconds until the top LED in the LED bar begins blinking slowly and the controlled light flashes
2) Using an X10 controller, send the following sequence three times in succession: x10 primary address followed by the ON command
3) Once SwitchLinc Relay has received the preceding sequence three times, SwitchLinc will confirm that it has its Primary X10 Address by blinking the top LED in its LED bar and flashing the light that it's wired to
Just wanted to make sure, for (1) if I press and hold the paddle top for 10 seconds, top LED blinks, and the bottom LED blinks rapidly. Not sure what the "controlled light flashes" refers to - bottom LED?
For (3), the light never flashes and after 3 x10 commands, the paddle LED continues to flash. I'm using a Maxi controller and I can control other lights no problem.
Thanks for your assistance.