I see some discussions about the Cooper Z-Wave dimmers and it seems like they are working well for others. I just picked up a RF9540-N type dimmer and hooked it up. It works for local control, sending status to the Lumina panel correctly. I can send ON commands successfully as well, however, but the PC Access software and Haiku show the status as OFF after the command is sent for ON.
Anyone else seen this? I think I have an association setup and working, as using the switch locally sends proper status to Omni and it reports it the way I would expect (including dim status.)
But when I have the Lumina send the command for ON, the device goes ON, but then almost immediately the status shows as OFF on the Lumina.
Does anyone have the Coopers working properly with commanded status?
Thanks in advance.
Anyone else seen this? I think I have an association setup and working, as using the switch locally sends proper status to Omni and it reports it the way I would expect (including dim status.)
But when I have the Lumina send the command for ON, the device goes ON, but then almost immediately the status shows as OFF on the Lumina.
Does anyone have the Coopers working properly with commanded status?
Thanks in advance.