m_gustafsson
Member
I have a 6 ch hub, with a power adaptor connected to it. From the hub I have attached 4 daisy chains with the following sensors:
chain 1. barometer - temp/humidity/solar - temp/humidity/solar
chain 2. temp/humidity/solar
chain 3. rain gauge
chain 4. temp/humidity/solar
When I tried this setup yesterday it seemed to work fine, and I could detect all sensors. But when I tried to extend my fourth chain to:
chain 4. temp/humidity/solar - temp/humidity/solar - anemometer
none of the sensors on the fourth chain were detected. The other chains were still ok though.
I have tried to have just the two temp/humidity/solar attached on the chain, and I have also tried just one temp/humidity/solar and the anemometer on the chain, but with the same result.
If I remove the daisy chained attached sensors the first temp/humidity/solar on the fourth chain reappears again.
What can this problem be due to?
Thanks
/Mats
chain 1. barometer - temp/humidity/solar - temp/humidity/solar
chain 2. temp/humidity/solar
chain 3. rain gauge
chain 4. temp/humidity/solar
When I tried this setup yesterday it seemed to work fine, and I could detect all sensors. But when I tried to extend my fourth chain to:
chain 4. temp/humidity/solar - temp/humidity/solar - anemometer
none of the sensors on the fourth chain were detected. The other chains were still ok though.
I have tried to have just the two temp/humidity/solar attached on the chain, and I have also tried just one temp/humidity/solar and the anemometer on the chain, but with the same result.
If I remove the daisy chained attached sensors the first temp/humidity/solar on the fourth chain reappears again.
What can this problem be due to?
Thanks
/Mats