archstenton
Member
Finally getting to the point of hooking up the M1 so doubtful this is my last thread.
Went ahead and ran Cat6 between the data bus pieces. Although,due to whatever, just daisy chained it the cables, not home run.
This is the approximate layout
M1<---15 ft--->KP2<----5 ft---->M1XRF2H<----40 ft--->M1XIN
Since I got the 8 conductors, figure will double up the data.
But was wondering should I wire maybe the M1XIN for power in parallel with the last 2 spare wires? In the M1 manual for home runs, it mentions don't daisy chain the power due to unnecessary voltage loss. So if I have a spare pair, does it make sense to do some combo of parallel power run with them?
Went ahead and ran Cat6 between the data bus pieces. Although,due to whatever, just daisy chained it the cables, not home run.
This is the approximate layout
M1<---15 ft--->KP2<----5 ft---->M1XRF2H<----40 ft--->M1XIN
Since I got the 8 conductors, figure will double up the data.
But was wondering should I wire maybe the M1XIN for power in parallel with the last 2 spare wires? In the M1 manual for home runs, it mentions don't daisy chain the power due to unnecessary voltage loss. So if I have a spare pair, does it make sense to do some combo of parallel power run with them?