treo650
Active Member
Hello, need some help please..
I've been searching, but I can't get a clear answer so I thought I'd ask.
I currently have a working m1 gold setup with a standard one M1KP keypad setup.
1) I read that I am able to connect two data devices to the m1 gold directly, so am I able to parallel connect the M1xrf2h via home runned to the panel?
2) I also have a spare M1DBHR laying around, so I plan to add this. But of I do add this, do I now put the KP1 keypad on port 1 of the hub? And wireless on port 2? Is adding the hub considered better than running two devices parallel to the panel, or is it not necessary for two devices?
I figure I have it laying around, it can't hurt?
3) do I need to do anything special on the KP2 software to reenroll the keypad if I add the M1DBH? Will the panel still recognize the keypad setup or must it all be re-set up?
4) how about the jumpers? I read that there is a JP1 jumper on the wireless M1XRF2H, do I need to do anything to it for my setup?
I currently have only 1-12 wired cones connected
5) the M1xrf2h is a used unit from eBay.. Should I hard reset it first? How do I hard reset this before hooking it up?
Thanks in advance for the help
I've been searching, but I can't get a clear answer so I thought I'd ask.
I currently have a working m1 gold setup with a standard one M1KP keypad setup.
1) I read that I am able to connect two data devices to the m1 gold directly, so am I able to parallel connect the M1xrf2h via home runned to the panel?
2) I also have a spare M1DBHR laying around, so I plan to add this. But of I do add this, do I now put the KP1 keypad on port 1 of the hub? And wireless on port 2? Is adding the hub considered better than running two devices parallel to the panel, or is it not necessary for two devices?
I figure I have it laying around, it can't hurt?
3) do I need to do anything special on the KP2 software to reenroll the keypad if I add the M1DBH? Will the panel still recognize the keypad setup or must it all be re-set up?
4) how about the jumpers? I read that there is a JP1 jumper on the wireless M1XRF2H, do I need to do anything to it for my setup?
I currently have only 1-12 wired cones connected
5) the M1xrf2h is a used unit from eBay.. Should I hard reset it first? How do I hard reset this before hooking it up?
Thanks in advance for the help