Fire Zone Data in PC Access

[DeputyDawg]

I have a Omnipro II board using Dealer PC Access.  In the Zones setup when I add Fire to Zone 5, is the Zone Type set to Fire or Auxiliary or what? Would it be the same regardless of what Zone I put Fire in realizing that Zone 1 and Zone 5 are customary for this feature.
 
Any other software feature(s) I need to look at in PC Access when adding a Fire Zone?

 

[ano]

Any zone can be a fire zone, but the first four zones can be configured as 2 wire or 4 wire fire zones, the others are always 4 wire zones. You can have a 4 wire fire zone on zone 5, just set it appropriately. If its a fire zone, set it to fire.