HB Barometer and Weather Display setup

geewizard

New Member
Just received a HB barometer and power injector. Weather Display sees the barometer and shows a 1-wire address. I have entered the calibration information supplied with the sensor.

The problem I'm having is that since the barometric pressure is not that of the nearest airport, I need to add an offset within Weather Display. When I do add in the offset, and it's -1.077 inches, I don't see any change in the indicated pressure.

Is this a problem with the sensor or a problem with Weather Display?
 
The best place to ask Weather Display questions is over at http://www.weather-watch.com. You may be putting the offset in the wrong place. I know that Weather Display sometimes has strange places to put offsets.

Another thing you can do is to tweak the calibration pot to get it as close to the nearest airport as possible. Just make sure to barely turn it because it doesn't take much of a turn to change the calibration a good bit.

Eric
 
Back
Top