ElkridgeTerp
New Member
DIYer here. I've replaced my very old Omni system with the Elk M1 Gold. I've kept the existing X-10 until I get around to replacing with Insteon. Everything thus far seems to work, X-10 control, Email (yes I got that to work), alarms, rules, etc. I've installed my first Insteon switch and am able to control it via the ISY software. The ISY software is current. I've purchased the Elk Module for the ISY software. I've done an export from ISY and import into the Elk RA software. Elk M1 and network interface are current for both boot loader and firmware. The Insteon switch shows up in my lighting list, so the export/import appears good. The ISY software sees my Elk zones, so the two systems see each other. Problem is I can't seem to control the Insteon switch via the Elk system. I can see it on the control panel, but there is no response to any on/off commands.
Any suggestions are greatly appreciated. I'm at work right now, so I won't be able to test anything right away, but will respond back with results for future readers.
Any suggestions are greatly appreciated. I'm at work right now, so I won't be able to test anything right away, but will respond back with results for future readers.