*** Honeywell 5811

[Mp333]

Couple of the Honeywell 5811 will not register with M1XRF2H. Others had no problem with it.
Not sure what could be the reason. I did try new battery's.

 

[Del91574]

How are you getting them in the system?

I'd recommend notating the ESN and then using RP to program. You might be learning in the incorrect (tamper) loop and not the reed.

 

[Mp333]

How are you getting them in the system?

I'd recommend notating the ESN and then using RP to program. You might be learning in the incorrect (tamper) loop and not the reed.

DEL,
I am enrolling these using the ElkRP. I set them up as loop 1 & EOL Supervised/ RF. I set quite a few up with out any issues.
"You might be learning in the incorrect (tamper) loop and not the reed." Not sure I understand this.
 
Thank you

 

[Del91574]

I would notate the ESN's and program that and the appropriate loop via RP before going the "learning" route.
 
The units might not be closed and the tamper is actually tripped or the batteries might be the issue.