Figured out scenes on the remote (finally!!!!)
Note that what wasn't explicit in the following is that after you get the following message, you can individually change every level of every zone to a desired level. Hitting button 1 at that point saves all those levels in the scene. Note that because the scene is forced to be linked to the devices by area/zone, you need a dedicated area(zone) with all devices you wish to specify in the scene.
I still say doc sucks and this is not intuitive and i didn't think other products required a zone to be defined on which to base the scene.
thx
-brad
Email from Lutron
===========
An area can be a group of devices up to 32, or a single device. There are 16 profiles total that you can create in your remote with 4 areas to each profile.
Illustration: If you create profile 1 you then can associate area 1 to button 1 area 2 button 2 and so on. Each one of these created area can have up to 32 devices grouped in that area or have a single device. Once your profile is created and you have linked areas to each button if you press and hold button 1 ON for 15 sec you will get a display that says ADJUST LEVEL FOR THIS SCENE PRESS 1 ON WHEN DONE. You can repeat this for all button in that profile.