M1G Shows Violated at Power Up, Then OK

[DotNetDog]

I am in the process of installing my M1G and I just noticed something odd. When I power up everything the keypads show violations (ElkRP shows most zones violated), then after a couple of minutes the zones report OK and the system is ready to arm.

I understand that there is a "warm-up" period but I don't remember seeing zones as violated until today.

Is this normal?

 

[gatchel]

What firmware are you running in the M1? I remember this was/is an issue for zone expanders, (I think). I'd have to check the release notes.

 

[DotNetDog]

What firmware are you running in the M1? I remember this was/is an issue for zone expanders, (I think). I'd have to check the release notes.

Device Hareware Ver Boot Ver Firmware Ver
M1G 0.13 3.3.6 2.1.48
M1XIN 0.5 3.0.5 1.3.7

 

[video321]

It is normal to see zones violated on the XIN during bootup. IIRC the latest firmware update will still show this but the m1 ignores them for something like 1 min.