shenandoah75
Active Member
All the device drivers i see on the ML / CQC pages list either full dolby/surround based receivers or higher end multi-zone stuff like RNet, etc... If i only need one zone, is there any supported RS-232 controllable stereo preamp or receiver that i can use as my base. I was going to use my main HT receiver for this, but have decided against it for a couple of reasons (including the wife's decision to change what room with be the HT setup).
Would Like:
1) control selected input via a single Air Panel or similar (FM/Server/Cable/ipod/etc)
2) mute or decrease volume on the the outputs for whole house at once (i.e. upon an incoming call, doorbell for example, or a mute button on the touchscreen)
3) use the CQC with jriver or ML for gui selection (thanks for the tips on previous posts, i'm now sold on this)
4) line level outs would go to russound 12 channel amp - to in wall VCs (no in wall selection/control)
Or do i need to go with some sort of IR-learning PC device for something this simple? I only want the impendence matching round kno VC's in the walls for each room (with maybe a local mute switch). I would not want to control with remotes, only the touchscreen.
thx
-brad
Would Like:
1) control selected input via a single Air Panel or similar (FM/Server/Cable/ipod/etc)
2) mute or decrease volume on the the outputs for whole house at once (i.e. upon an incoming call, doorbell for example, or a mute button on the touchscreen)
3) use the CQC with jriver or ML for gui selection (thanks for the tips on previous posts, i'm now sold on this)
4) line level outs would go to russound 12 channel amp - to in wall VCs (no in wall selection/control)
Or do i need to go with some sort of IR-learning PC device for something this simple? I only want the impendence matching round kno VC's in the walls for each room (with maybe a local mute switch). I would not want to control with remotes, only the touchscreen.
thx
-brad