smitty_kiwi
New Member
Hi,
I have a site at http://www.alpnz.co.nz/wx which reports a solar reading. However in the middle of the day, I believe the sensor becomes either too hot, or too something, overloads, and reports zero mV, in the wdisplay software.
However if I view the sensor in onewire viewer it has an output of .255 mV on the 3 channel. Do I input a value of say .275 as the maximum mV capability of the sensor into wdisplay?.
The solar sensor has been modified, in that the legs have been extended, and the board water protected, and housed in a Young Gill plate RS. with a hole drilled in top for the sensor to protrude trough. The sensor is covered with a glass medicine vial.
I will provide a photo next time I am up there.
Any help gratefully accepted.
I have a site at http://www.alpnz.co.nz/wx which reports a solar reading. However in the middle of the day, I believe the sensor becomes either too hot, or too something, overloads, and reports zero mV, in the wdisplay software.
However if I view the sensor in onewire viewer it has an output of .255 mV on the 3 channel. Do I input a value of say .275 as the maximum mV capability of the sensor into wdisplay?.
The solar sensor has been modified, in that the legs have been extended, and the board water protected, and housed in a Young Gill plate RS. with a hole drilled in top for the sensor to protrude trough. The sensor is covered with a glass medicine vial.
I will provide a photo next time I am up there.
Any help gratefully accepted.