Hello all,
I'm hoping someone can assist with an issue I am having with my Omni IIe and recent addition of the Wireless Receiver 45A00-1. My understanding is that when connecting the Wireless Receiver you are suppose to use the 4 ports mark console on the controller. I already have a console connected to the controller so I proceed to wire up the new wireless receiver in parallel. However, when I do this the wireless receiver mode light just blinks 4 times a second indicating that it is not communicating to the controller. I have followed the instructions to make sure it has "A1" and "n1" set and have also enabled the Wireless Receiver on the console but it still will not work. The console appears to work without any issues and I am able to register wireless transmitters to the receiver and the appear to communicate fine. I just cannot get the wireless receiver to communicate to the controller. To further troubleshoot I removed the console from the controller and then the wireless receiver started communicating without any issues. This leads me to believe that I have not wired something up properly. I have attempted to find documentation on how to wire both the console and the wireless receiver at the same time but I have not had any luck. Anyone have any ideas as to what I am doing wrong? Is the Console and Wireless Receiver supposed to be wired in series as apposed to parallel?
Thanks in advance for any suggestions.
I'm hoping someone can assist with an issue I am having with my Omni IIe and recent addition of the Wireless Receiver 45A00-1. My understanding is that when connecting the Wireless Receiver you are suppose to use the 4 ports mark console on the controller. I already have a console connected to the controller so I proceed to wire up the new wireless receiver in parallel. However, when I do this the wireless receiver mode light just blinks 4 times a second indicating that it is not communicating to the controller. I have followed the instructions to make sure it has "A1" and "n1" set and have also enabled the Wireless Receiver on the console but it still will not work. The console appears to work without any issues and I am able to register wireless transmitters to the receiver and the appear to communicate fine. I just cannot get the wireless receiver to communicate to the controller. To further troubleshoot I removed the console from the controller and then the wireless receiver started communicating without any issues. This leads me to believe that I have not wired something up properly. I have attempted to find documentation on how to wire both the console and the wireless receiver at the same time but I have not had any luck. Anyone have any ideas as to what I am doing wrong? Is the Console and Wireless Receiver supposed to be wired in series as apposed to parallel?
Thanks in advance for any suggestions.