I have an OmniPro II that I had professionally installed about 9 years ago. My firmware is version 3.4. It not flash upgradable.
I have Dealer PC Access, snaplink and H@me iphone app.
About 2 weeks ago problems started. I have narrowed the problem down to the OPII is not executing the code that is programmed into it.
I can turn on and off individual lights with the H@me iphone app or at the touchpanels.
H@me app shows that various motion detectors are working.
But I have several lighting scenes that are programmed as Buttons. Day mode, Goodnight mode are buttons. But when I press these, they do no execute.
Also, in my walk in master closet, the lights are supposed to turn on automatically for 5 minutes when triggered by the motion detector. We also have a motion detector on the front porch that is supposed to turn on due to motion.
I have tried resetting my OPII (by cutting power and disconnecting backup batteries). I have also exported and imported the programming out of and into the OP using PC Access.
Any suggestions?
I have Dealer PC Access, snaplink and H@me iphone app.
About 2 weeks ago problems started. I have narrowed the problem down to the OPII is not executing the code that is programmed into it.
I can turn on and off individual lights with the H@me iphone app or at the touchpanels.
H@me app shows that various motion detectors are working.
But I have several lighting scenes that are programmed as Buttons. Day mode, Goodnight mode are buttons. But when I press these, they do no execute.
Also, in my walk in master closet, the lights are supposed to turn on automatically for 5 minutes when triggered by the motion detector. We also have a motion detector on the front porch that is supposed to turn on due to motion.
I have tried resetting my OPII (by cutting power and disconnecting backup batteries). I have also exported and imported the programming out of and into the OP using PC Access.
Any suggestions?