Hi,
I got an OmniProII with FW chip 2.16. It used to have FW chip 2.11 but the chip was replaced (with a flashable chip I hope). I got PC Access 3 and downloaded the new FW 3.0 and 3.0A. The "upgrade firmware" option is not greyed out. When I select upgrade firmware and select the OmniProII file I immediately get a message "update failed", even before it starts to erase the chip. I also got PC Access 2.16a and when I try to upgrade the chip to FW 2.16a it also fails immediately.
I connect via ethernet.
Any ideas why it would fail?
Thanks
I got an OmniProII with FW chip 2.16. It used to have FW chip 2.11 but the chip was replaced (with a flashable chip I hope). I got PC Access 3 and downloaded the new FW 3.0 and 3.0A. The "upgrade firmware" option is not greyed out. When I select upgrade firmware and select the OmniProII file I immediately get a message "update failed", even before it starts to erase the chip. I also got PC Access 2.16a and when I try to upgrade the chip to FW 2.16a it also fails immediately.
I connect via ethernet.
Any ideas why it would fail?
Thanks