Hello all -
I have an OPiie with the VRC0P (updated to the latest firmware on both). I use TZ45 stats with the system. I am able to adjust temps indivudally just fine (thru HaikuHelper and console).
However, when I write in automation rules to say, at 7a set the upstairs stat to 75 and the downstairs to 73, both get set to 73. It's like the HAI pushes out the rules to both stats. Drives me nuts that I can not have automation for my thermostats.
Down is Zwave Node ID - 7
Up is Zwave Node ID - 8
Example automation code below:
13. TIMED 5:05 PM MTWTFSS
THEN Up COOL SETPOINT 75
THEN Up HEAT SETPOINT 69
14. TIMED 5:01 PM MTWTFSS
THEN Down COOL SETPOINT 73
THEN Down HEAT SETPOINT 71
I have an OPiie with the VRC0P (updated to the latest firmware on both). I use TZ45 stats with the system. I am able to adjust temps indivudally just fine (thru HaikuHelper and console).
However, when I write in automation rules to say, at 7a set the upstairs stat to 75 and the downstairs to 73, both get set to 73. It's like the HAI pushes out the rules to both stats. Drives me nuts that I can not have automation for my thermostats.
Down is Zwave Node ID - 7
Up is Zwave Node ID - 8
Example automation code below:
13. TIMED 5:05 PM MTWTFSS
THEN Up COOL SETPOINT 75
THEN Up HEAT SETPOINT 69
14. TIMED 5:01 PM MTWTFSS
THEN Down COOL SETPOINT 73
THEN Down HEAT SETPOINT 71