I called Ultimate and they told me that record show they did not change the default password (I suppose that alone should make me nervous about them) - they walked me through verifying that over the phone. Now I need a programming manual (which they refused to provide).
I have an older GE Concord 3 that came with my house that I am trying to find the installer, dealer and master user codes for but don't want to brute force entering 10,000 codes to figure it out. I have been reading on several forums that people have purchased EEPROM programmers and are reading the codes off the EEPROM. I am bought an EEPROM programmer and tried to use PonyProg software to read my new Concord 4 EEPROM to see what I could see but it seems to have messed up some of the data and now cause me a couple of issues. My first question is do you know what EEPROM programmer and software that I would need to do this? My second question is do you know where I can purchase just the EEPROMs to fix my old board so I can use it and possible by one for my new Concord 4 if I can't fix the Bus 4 failure issue that it seems to have now?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
