Does the Elk software allow you to create events based upon the current operating mode reported by the thermostat?
In my Homeseer 2 setup, the thermostat would report that it was in stage 1 (or whatever) stage heat as an operating mode. I used that information to trigger other events. Since HS3, I cannot access these status changes to trigger events.
The standard answer is to upgrade the thermostats, but I do not want to go to a cloud-based thermostat solution for a multitude of reasons. Therefore...I'm looking into options to get these to work reliably.
Thanks for any thoughts
In my Homeseer 2 setup, the thermostat would report that it was in stage 1 (or whatever) stage heat as an operating mode. I used that information to trigger other events. Since HS3, I cannot access these status changes to trigger events.
The standard answer is to upgrade the thermostats, but I do not want to go to a cloud-based thermostat solution for a multitude of reasons. Therefore...I'm looking into options to get these to work reliably.
Thanks for any thoughts