Hi
I just receive my order today, and I have some questions and comment about it.
- I order a hub, and there is 1 green leds ,ad 3 red leds
I plug an 18V power supply 0.8A, and the green leds goes on.
My question is , when do the red leds goes on. I did plug your pressure sensor and
also a temp sensor, and no red light ???
I also try to remove the jumper, same things
- Since I plug the hub to my DS9097U, it seem that it doesn't work anymore.
I had it working for many years with Misterhouse, but now, I can't detect
any devices. I plug back my original network, and nothing is working.
May I have done something to break it. My connection between the DS9097 and the hub
is only a 2 wire connection, so no power could goes on the wire.
I also plug it on my laptop, and install the windows software, same issue (sorry, only my
laptop have windows installed)
- how could I test if my DS9097U is working fine
- I will put 2 sensors/board outside, Have you ever use liquid tape to protect them
- Finally one comment about the board.
The hub doesn't have any attach point, so it is very hard to secure in a little case,
any idea on how to do it
The sensor do have 2 point, and I could probably find a way to box it.
Thank You
PS: If I get this working, I will post my experience using the board with Misterhouse
I just receive my order today, and I have some questions and comment about it.
- I order a hub, and there is 1 green leds ,ad 3 red leds
I plug an 18V power supply 0.8A, and the green leds goes on.
My question is , when do the red leds goes on. I did plug your pressure sensor and
also a temp sensor, and no red light ???
I also try to remove the jumper, same things
- Since I plug the hub to my DS9097U, it seem that it doesn't work anymore.
I had it working for many years with Misterhouse, but now, I can't detect
any devices. I plug back my original network, and nothing is working.
May I have done something to break it. My connection between the DS9097 and the hub
is only a 2 wire connection, so no power could goes on the wire.
I also plug it on my laptop, and install the windows software, same issue (sorry, only my
laptop have windows installed)
- how could I test if my DS9097U is working fine
- I will put 2 sensors/board outside, Have you ever use liquid tape to protect them
- Finally one comment about the board.
The hub doesn't have any attach point, so it is very hard to secure in a little case,
any idea on how to do it
The sensor do have 2 point, and I could probably find a way to box it.
Thank You
PS: If I get this working, I will post my experience using the board with Misterhouse