Premise Setting up z-wave module in Premise

[mhilbush]

Not presently, but it looks like it would be easy to add support for it.

There are a few things that are needed, such as the Manufacturer ID, Product Type, and Product ID. I usually get these over on the open-zwave project on code.google.com. But, I don't see the HSM02 listed there.

http://code.google.com/p/open-zwave/source/browse/trunk/config/manufacturer_specific.xml

 

[etc6849]

Did you try excluding and re-including the device using the Leviton RF Installer Tool (http://www.leviton.c...&minisite=10251)? Definitely the first step to installing is to check it's functionality inside the RF Installer tool software. In other words, you should always actuate the device and check its status inside the RF Installer Tool Software after you have added it and performed a network rediscovery. However, it should be noted that some devices may not be fully supported in the RF Installer Tool, so sometimes you have to rely on Premise and the VRC0P for debugging. I'm not sure if the HSM02 is one of these devices or not.

Also, can you contact the manufacturer and ask how to reset the device? Usually excluding it from the network with the RF Installer Tool resets the device though...