Hi there cooconers
I just purchased a signalinc (2406H), and looking at the installation manual. From what I understand from the drawing, I must use 2 circuits on the same bus bar in the power panel.
however, step 16 states that I should use 2 different legs, which seems to go contrary of the drawing.
I always tought that for bridging the signal, I had to indeed effectively bridge the 2 sides, so step 16 is right, but why keep a wrong drawing then?
Who's right, and who's wrong????
please help me before I burn down my house!
for the manual:
cache-m2.smarthome.com/manuals/2406h.pdf
Thanks in advance for all help and pointers you can provide,
Spou
I just purchased a signalinc (2406H), and looking at the installation manual. From what I understand from the drawing, I must use 2 circuits on the same bus bar in the power panel.
however, step 16 states that I should use 2 different legs, which seems to go contrary of the drawing.
I always tought that for bridging the signal, I had to indeed effectively bridge the 2 sides, so step 16 is right, but why keep a wrong drawing then?
Who's right, and who's wrong????
please help me before I burn down my house!
for the manual:
cache-m2.smarthome.com/manuals/2406h.pdf
Thanks in advance for all help and pointers you can provide,
Spou