Trouble adding RZC0P to network

[Deane Johnson]

I'm trying to get my Z-Wave network setup. Right now, it's just one Leviton dimmer and an HA06 lamp module.

I'm using Control Think and a ThinkStick for the controller. The two devices mentioned above added just fine and I can control them as expected in the ControlThink software.

When I try to add the RZC0P to the network so I can interface with my HA software (Elve), it's not happening.

I have reset the module to the factory settings, and it just sits there and blinks green. When I try to add it, when I push the flashing green button, the Control Think software says that the device has been found, then says "no device added".

I can't figure out why I can't add the device. Any ideas.

Thanks.

Deane

 

[ASIHome]

Make sure you are running v2.5 Beta (build 1). Do not use build2. To get to that version, do not use the update built into TE. Get it from here: TE 2.5 Beta (Build 1)

Once you have that up and running you will have a new button called "Include Controller".

 

[Deane Johnson]

Make sure you are running v2.5 Beta (build 1). Do not use build2. To get to that version, do not use the update built into TE. Get it from here: TE 2.5 Beta (Build 1)

Once you have that up and running you will have a new button called "Include Controller".

I think I have the correct version. In the box titled "About ThinkEssentials" it says Version 2.5 (build 1). The word "beta" is not there, however.

I also don't find a button "Include Controller". On the "Home" screen there is an "Add Device" and an "Add Controller". Both perform the same way, that is, in response to my pushing the flashing green button they give the message Device (or Controller) found, then the message Device (or Controller) not added".

Am I going wrong somewhere in this chain of events?

Deane

 

[ASIHome]

Add Controller is correct, sorry for the typo. To include the VRC0P, you must press and hold the button until the LED turns Amber. Once the LED turns Amber, press the Add Controller button. It will prompt you to hit the button on the VRC0P, DO NOT do this, it will recognize it since it is in include mode. If it does not add this way, reset it by pressing and holding the button down until the LED flashes RED. Then try the above steps.

 

[Deane Johnson]

Wow, that worked on the first try.

Instructions are just a little lacking on this.

Thanks for your help Barry.

Deane

 

[Deane Johnson]

After the RZC0P is added and is working correctly, is it normal for the green light to be blinking permanently? Mine does.

Thanks

Deane

 

[johnlaroux]

After the RZC0P is added and is working correctly, is it normal for the green light to be blinking permanently? Mine does.

Thanks

Deane

Mine does also.