Folks, Just new to HA and trying to get some devices installed. So far I've installed 6 UPB devices\switches that turn on lights. This is controlled by my PC running HomeSeer2 connect via a PIM.
I need to control some of these UPB devices via a Hawkeye Motion sensor. I've configured the sesors to A1,B2,C3. MY questions are:
1. HOw do I configure these devices on the UPB572 - My NID is 117, should I check A,B&C, Use a NID of 117, and X10UC of 1,2,3 respectively for the 3 motion sensors.
or - do I have to create it as a link - how should I do this
2. How should I make UPstart see these new moption sensors, since it can't write to them.
3. How do I control them via the homeseer, as a UPB device or Link based on #1
Any help would be greatly appreciated.
I need to control some of these UPB devices via a Hawkeye Motion sensor. I've configured the sesors to A1,B2,C3. MY questions are:
1. HOw do I configure these devices on the UPB572 - My NID is 117, should I check A,B&C, Use a NID of 117, and X10UC of 1,2,3 respectively for the 3 motion sensors.
or - do I have to create it as a link - how should I do this
2. How should I make UPstart see these new moption sensors, since it can't write to them.
3. How do I control them via the homeseer, as a UPB device or Link based on #1
Any help would be greatly appreciated.
