I have about 20 UPB switches throughout the house and only had an issue with one on install until today.
One of the upstairs switches doesn't respond at all to local commands (Single rocker). It worked fine only using remote (iPhone of HS interface). Tried putting it into setup and nothing. So being dumb I deleted it from my UPB setup, recycled the breaker and now its powered on, can't turn off locally and of corse since I deleted it, won't turn off remotely either.
Is there a way to force a factory reset that doesn't involve using the paddle switch? Is this switch shot?
One of the upstairs switches doesn't respond at all to local commands (Single rocker). It worked fine only using remote (iPhone of HS interface). Tried putting it into setup and nothing. So being dumb I deleted it from my UPB setup, recycled the breaker and now its powered on, can't turn off locally and of corse since I deleted it, won't turn off remotely either.
Is there a way to force a factory reset that doesn't involve using the paddle switch? Is this switch shot?