shenandoah75
Active Member
I installed think essentials with my existing network and went to look at signal strength. In some cases, devices all but a few devices are listed as direct neighbors to the rzcop. In the remote, there is an association listed between the two devices. Most of the time commands issues through the rzcop do not occur on the missing node. I've tried network rediscovery on the remot, etc to no avail.... However, rebuilding the network with the thinkessensials and the stick fixed some of the nodes i expected to be direct neighbors, but not all (signal strength between it and the rzcop is good).
1) I'm assuming this means there is no direct path between the devices...
2) why would i see direct relationships bettween and A and B but not A & C when B & C are in the same j-box?
3) Is there anyway to force nodes to become "direct neighbors" using the remote ?
4) Any other ramifications?
Even after doing this 99% of the time, commands from the rzcop fail to register on the one problematic node (node 24) but commands work fine from the usb stick
5) i made the usb stick the primary controller just to see what would happenexpecting to have to prompt the Vizia remote to join as secondary. That didn't occur so control think sees it self as primary as does the remote. Should the be permitted and any issues?
thx in advance
-brad
(ps. all devices are viziarf, not +... I am about to reset all and use the new, updatable remote for the primary controller, but figured i'd test what i'm having issues with)
1) I'm assuming this means there is no direct path between the devices...
2) why would i see direct relationships bettween and A and B but not A & C when B & C are in the same j-box?
3) Is there anyway to force nodes to become "direct neighbors" using the remote ?
4) Any other ramifications?
Even after doing this 99% of the time, commands from the rzcop fail to register on the one problematic node (node 24) but commands work fine from the usb stick
5) i made the usb stick the primary controller just to see what would happenexpecting to have to prompt the Vizia remote to join as secondary. That didn't occur so control think sees it self as primary as does the remote. Should the be permitted and any issues?
thx in advance
-brad
(ps. all devices are viziarf, not +... I am about to reset all and use the new, updatable remote for the primary controller, but figured i'd test what i'm having issues with)