Voice Status Of Violated Zones

[Ed Nelson]

My ELK/M1 system has an end of day summary. The rules perform the following:
- Shut off the porch light at 11:00Pm (Insteon)
- Announce the time (11:00pm)
- Announce temp in wiring closet (I am monitoring this in anticipation of having to install a BreezeAir Unit)
- Shuts down waterfall (Insteon)
- Announce: ".. entering automation quiet mode..remain calm.."

I would like to have the system perform a readout of all zones currently violated that are not in bypass.

I have surmised a pretty elaborate logic set based on counter increments to possibly do this, but before
I embarrass myself, I wonder if there is a standard, embedded way to get the same results?

As an example, I'd like to have the system announce the following:
- Master Bath Door is Open
- Front Door is Open
- Kitchen Window is Open

Further, if no zones were opened, I'd like to secure such a status in order to
allow me to auto arm the system to "STAY" mode.

Thanks.

_ Ed

 

[BryanE]

I'm interested in this as well. Hopefully there is an easy way to achieve this. I was interested in doing something like this:

If Thermostat Mode is changed to anything but Off
Announce violated zones

 

[asteinmetz]

Similarly, can the status flags on the RM panel be filtered so only the violated zones show up? I have 7 pages of status flags to go through.

I'm interested in this as well. Hopefully there is an easy way to achieve this. I was interested in doing something like this:

If Thermostat Mode is changed to anything but Off
Announce violated zones