Zone Expander Settings

[DeputyDawg]

I have an OMNI Pro II board with an 16 Zone Expander 10A06-1

Under Expansion I have Module 1 set with Hardware Expander

In Zones Dealer Settings - should I have Expansion Enclosures set to 1?

In Units Dealer Settings - should I have Expansion Enclosures set to 1?

Anywhere else I should set the Expansion Enclosures set to 1?

 

[Desert_AIP]

The Expansion Enclosure settings are for the 17A001 Expansion Enclosure and wireless receivers.
If you have neither they should be set to 0.
It appears you have the bit set properly for a single Hardwire Expander.

 

[DeputyDawg]

To Desert_AIp thanks for the clarification. I read about the 17A001 and was not sure of the settings.