Recent content by bgoldak

I was the faced with the same problem last year when I upgraded my phone. It seems IOS no longer backs up the actual app, only a link to it in the App Store. So if it is no longer in the store, poof, its gone. All is not lost however. If you can find a back up file from your old iOS device...

Thanks, I didnt realize that AC POWER ON was a power up event. That should work. Have you seen this before? I am only assuming the errant phone calls are due to a startup glitch.

Thanks guys, I thought that my comments from the office edits overwrote the comments at the console end, but I must be wrong on that. Thanks for clearing that up so fast. Cheers

Hello, I have an OmniPro II and check every hour for temperature and humidity limits. If a limit is exceed I have the system phone me and tell me so. Trouble is that after a power failure and re-start, the system sometimes calls me and reports conditions that dont exist, and worse yet, it may...

Hi, I have a vacation home "cabin" that runs an Omnipro system. I do most of the programming there on weekends with PC Access, but like to occaisionally modify the code remotely from home or work. When I read the program from work, I get the current code from the cabin, but the embedded...

Hi, I have an HAI Omnipro system that controls a Lutron Homeworks lighting system. I have some outdoor lights that I want to run at low level for asthetics, but then run them up to 100% if there is a local motion sensor trip. I set the lights to low on a timed "at sunset" trigger and then if...

Hi, I'm new to this group and just about to throw out my own questions, but this one caught my eye. I have had the exact thing happen with Haiku and my Omnipro / Omnistat system. The problem is that you need to take the 'stat out of hold mode before making any changes to setpoints, etc...