Hello, I have an OmniPro II and check every hour for temperature and humidity limits. If a limit is exceed I have the system phone me and tell me so.
Trouble is that after a power failure and re-start, the system sometimes calls me and reports conditions that dont exist, and worse yet, it may call 10-20 times in the middle of the night.
Is there a synchronization problem that occurs at power up? I read the temps from the Omnistat thermostats and humidity from some HAI sensors.
I put a large computer UPS on the Omnipro to reduce this nusiance calling, but it still will happen if the power is out long enough to kill the UPS battery.
Any suggestions?
Is there a way to set a flag and timer at power up so I only consider calling out say, 10 minutes after power up?
Thanks
Trouble is that after a power failure and re-start, the system sometimes calls me and reports conditions that dont exist, and worse yet, it may call 10-20 times in the middle of the night.
Is there a synchronization problem that occurs at power up? I read the temps from the Omnistat thermostats and humidity from some HAI sensors.
I put a large computer UPS on the Omnipro to reduce this nusiance calling, but it still will happen if the power is out long enough to kill the UPS battery.
Any suggestions?
Is there a way to set a flag and timer at power up so I only consider calling out say, 10 minutes after power up?
Thanks