Recent content by kanipso

Ahh! IC Thanks.. Nothing is easy in this biz.

I ran into a problem trying to use a 1/8 mono cable to connect the output of my Xantec 789-44 repeater block. I assumed I could connect directly to the ocelot IR 'in' port from the ir 'hub.' When I make this connection the Ocelot wont boot. No lights nothing.. Luckily I did read in man where...

It is not a phase issue. I have checked that. Have you actually played a SACD or DTS/DVD audio source on your system? I am clearly not the only person having this problem. Some new decks even have compensation for this..

Yeah, I read that before trying. (lucky). I didn't hot plug it. And quickly removed power after realizing something was up. Either way how is it done?? It can't be that hard.

Ok, not so nub now.. I ran into a problem trying to use a 1/8 mono cable to connect the output of my Xantec 789-44 repeater block. I assumed I could connect directly to the ocelot IR 'in' port from the ir 'hub.' When I make this connection the Ocelot wont boot. No lights nothing.. What is...

Where's the bass?? What is going on. I have used multiple components all with the same result. Very little bottom end.. I have resorted to setting up a listening mode for DVD/SACD audio only. In this mode I have to peg the sub gain at +12db... This only provides moderate bass. All the high...

I used these guys to solve that problem. You can send 4 audio signals over one cat5 cable. The sound quality is surprisingly decent. You can also send video and digital (coax only). I have 2 100'+ runs working great. Muxlab

no real problems... Just getting used to it I guess.. I think I'm over it now. : )

Is there a way to use the 'old' style code editor interface. This new setup is SLOW going..

I just installed 2.0d.... What happened to the code editor? Where did everything go?

I haven't played with any of the IR funcionality of the Ocelot yet. Only regular logic stuff. I am going to try some basic stuff tonight.

WOW! I can't spelllll

It's a Viewsonic VGA/Composite switcher. Next Vision N4 Video Processor. It alows me to switch between my HTPC and the recievers OSD. The OSD is typically not displayed over component.

Thanks. I'm cheking that out now. Any ideas on the learning troubles. (other than my personal...)

Hey guys. Hope your holidays were nice. This is what I'm doing. I am building a dedicated theatre room. I have a wall rack and wiring closet. (sought after rear access) I am using the B&K AVR507 which ships with a brand labeled MX500 remote.. (IR version) I have a Xantech repeater and four...