Recent content by ktm250rider

Yes, i try find every time as well as search on the setup screen. Hmm, i only have the green light, no yellow

Yes

OK, basics. What lights are supposed to be on? Ive got the small light next to the power port and the gree light blinks on the ethernet port. Any others?

Thought maybe there was an issue with my work laptop I was using. So I used an old desktop I had. It's running ME but works fine. Checked the ip and set it to 192.168.0.102. Ping the XEP at 192.168.0.251 and get "request timed out". I'm just about to give up!

Still got nothing. XEP set to static, 2 quick blinks Crossover cable connected Windows vista, Network connections, local area connection, properties Select Internet protocol version 4(TCP/IPv4), properties, use the following ip address. I enter 192.168.0.100, subnet 255.255.255.0 Default gateway...

I'll play around with that a little. That all makes sense, I just need to know how to get there. I'm currently logged onto my router Netgear N300 WNR2000v2. Under the LAN setup, the "use router as DHCP server" is checked. I'm confused because the starting IP Address is 192.168.1.2 and ending...

Oh yeah, I've got the jumper thing and can switch from static to DHCP easily. I just can't get the two to connect.

ok, im a computer hack (not hacker) another dumb question. How do i check the subnet? Ive got a good crossover cable, checked with continuity meter. whats the process after the xover cable is attached?

Back at it after a little break. tried the let it sit and correct itself but that didnt work. I installed advanced IP scaner but i dont see the M!XEP when i do a scan. I get the green blinking light on the M1 but no indication on my router. I have two ports on the router that are connected...

I'm going to try the direct connect next Connecting with a cable from the computer to the panel

I'm confused, the directions say above to enroll the XEP through the keypad yet everyone says it's not. I can't find the XEP through ELKRP. I do the search and nothing is found. The lost comm issue started when I started working on the XEP.

Trying to enroll my xep and having no luck. I've got it set to DCHP, got a blinking green light (about every 3 sec). when I try to enroll it at my keypad, I get a KP Addr1 lost comm. Any ideas where to start? I'm not a computer genius but I can usually figure this stuff out.

I'm putting off the xep for now and trying to update the RP software. I've been running ver 1.6. I can't download ver 2 on the current computer that I'm using to connect to the control for various reasons. I have a new computer that has ver2 loaded. Is there an easy way to get my current...

well that was a dumb question because i got into the screen finally. Now I cant seem to get the xep to connect to my router. I get a couple of green light flashes then nothing. Cant "find" it?

This is where the question starts to get dumb. I do have RP, and thought that it was the box that says "RP access code". When I started RP it was blank. I put in a code but that didn't work. so am I in the right box?