Recent content by Oznavad

  1. O

    Sprinkler wiring to Omni Pro confusion

    I've had my 8 sprinkler zones run by my OP2 for years in an expansion panel and 8 relay board. Over the years, I've had a few solenoid failures each year. While changing a couple this spring, I tested the leads with the zone off and notice I'm getting 12-15V AC. When the zone is on I get 26V. It...
  2. O

    Basic Hardware/Software set up for Omnipro 2 and Homeseer

    Thank you Pete, Status screen on PCA shows 3.10 firmware. I seem to recall replacing the chip(s) way back when. Looking at the panel, one chip says 3.10 and the other 2.0. Is that OK? Here's a photo of the panel. I have no Linux knowledge so I guess I will get a windows version and put it on a...
  3. O

    Basic Hardware/Software set up for Omnipro 2 and Homeseer

    I'm looking for some basic guidance on what I need to add Homeseer to control my OmniPro2 panel so I can integrate some other systems into HS at some point. My OP2 was installed in 2006. My set up controls security, fire, about 20 HLC switches, pool pump, outdoor lighting, sprinklers and a few...
  4. O

    HAI Dimmer problems

    You got it! It was LED bulbs causing the noise. Need to see if it was the LED sconce bulbs or the recessed LEDs. Great thanks Ano and Mike. Saved me a lot of head scratching
  5. O

    HAI Dimmer problems

    I've reset them both multiple times. And yes, there were conventional switches that worked fine.
  6. O

    HAI Dimmer problems

    I have an OP2 setup with 30 or so HAI dimmers around the house. I've been having issues with couple of newly installed dimmers on a single circuit that feeds multiple light loads around a back door.  One HAI dimmer controls "Back Door Outside" - 2 recessed lights and 2 sconces. The second...
  7. O

    HAI Omnistat questions

    Maybe the issue is with 24v coming from ac unit, though it does go on eventually, No flickering at the stat, only noticable outside at compressor. The second stat will control same model trane. I'll see if it behaves the same. The radiant heat just triggers a circulator pump to the manifold so...
  8. O

    HAI Omnistat questions

    I have an omnipro ii panel and have recently aquired a couple of rc2000's.. Somewhat of a HA rookie and trying to figure some of the install out. First, the install manual references a comm jumper. My stats dont have them. Did early versions not have the comm jumper? Currently im just using...
See more
Back
Top