I have an OP2 setup with 30 or so HAI dimmers around the house. I've been having issues with couple of newly installed dimmers on a single circuit that feeds multiple light loads around a back door. One HAI dimmer controls "Back Door Outside" - 2 recessed lights and 2 sconces. The second controls "Back Door Inside" - 3 recessed lights in soffit over door inside. There is also a standard switch that controls two sconces inside the door on the same circuit. The circuit also powers a couple of ceiling lights in the pantry. Typical grabbing hot wherever it is during some remodeling.
So here's the issue - I have perfect control of the inside dimmer as long as the outside dimmer is off. When the outside is on, I can't control the inside. The outside dimmer will go on by command, but won't turn off.
I have changed the outsdie dimmer with a new switch, same results. My guess is some issue created through the adhock wiring of this circuit that is throwing off communication, but not sure what type of wiring configuration would lead to such problems. Maybe improper tying together of neutrals??Any thoughts?
So here's the issue - I have perfect control of the inside dimmer as long as the outside dimmer is off. When the outside is on, I can't control the inside. The outside dimmer will go on by command, but won't turn off.
I have changed the outsdie dimmer with a new switch, same results. My guess is some issue created through the adhock wiring of this circuit that is throwing off communication, but not sure what type of wiring configuration would lead to such problems. Maybe improper tying together of neutrals??Any thoughts?