Recent content by pbeaulieu

Thanks, alot dwalt. I looked all over the owners manual and the internet. Foolish me I forgot to look at the install manual. You start loosing brain cells as you get older. Thanks again.

I have 2 Omni Pro II consoles. One labeled HAI and the other labeled Leviton. The HAI labeled panel has buttons that light up with they are pushed and then go off after a period of time. The Leviton labeled panel has buttons that are light up all the time, they never go off. Is there any way...

I have been using the OmniPro II for 10+ years. A small setup with 35 zwave devices including 2 locks, driveway sensors, and other stuff. I wanted to include new zwave hardware but the VRCOP was limiting. I decided to use Homeseer HS4 and move all the z-wave devices to being controlled...

What confused me is that the software reports that it is version 3.11.4.691 I guess the 4 is a typo.   Thanks for the replies.

I just noticed that HAI has released PC access 3.11.4.691 and firmware 3.11D but I did not see any info in the release notes.  Can HAI supply some info on what has changed/new in this release?   Thanks,

I just saw a press release from HAI by Leviton:  "HAI by Leviton Announces Yale Real Living™ as Latest Connectivity Partner"   In the release it mentions firmware version 3.14 or later.  Last I saw the firmware was 3.11c.   Is firmware version 3.14 a new version that is going to be released?  If...

Well in the past I have called Leviton support for zwave, vrcopv3 and warranty on a regular switch. I always received very good support and the support staff was friendly.

I use a HAI OmniPro II to control my Yale Locks. Here is a thread in this forum where I describe what I did. Read to the end there is an interesting way to use one VRCOP that another user details.

I'm not an expert but I believe the vrcop can control non Leviton products. However, assuming you are using the Leviton RF+ software to configure your network, then by associtation I assume you mean the ability for the Leviton products to automatically transmit their status change to the...

I agree with Standon also. I use to have just punch downs but my better half complained that if we were to sell the house who would understand what to do other then a geek (like her husband :) ). The Leviton stuff is available at Home Depot and local electric stores. So just about anyone who...

Brian, Not sure what you are asking. I look at my post and it is what I am currently using. The "Side Door code received" is message 40. The "Basement Door code received" is message 50. Hope you get it working. Sorry it took so long for replying but my internet was out for a couple of...

Depends on how much performance versus power you want. The Intel I3-2120T is a 35W Dual core 4 thread processor. The are lower powered atom processors but I have not looked at them much. I'm looking to build a low powered server but I still want some performance.

What version of WHS are you using?

Sorry JWA1D62. I have been traveling (currently in hotel room). I must have missed your previous message. Hopefully, 6d.dennerline has answered most of your questions. I don't know if Leviton has changed their RF Installer program but originally it did not work with the ControlThink USB.

You certainly can look at ELK or HAI as a platform. There are lots of discussions in this forum on the pros and cons of both systems. I have an HAI OmniProII. You can connect via rs232 or preferrably use the built-in network port. You have to request the HAI SDK from the vendor but I...