Hi All
Just trying to work out the best possible way to identify remotely, which zone triggered an alarm on my M1 Gold
I'm currently running Ek Alarm to access remotely but that will not show which zone triggered the alarm if the zone becomes sealed again during alarm.
I also have the system...
I forgot to mention some other details - my panel was replaced along with the PSU about a year ago after a storm. The new panel was supplied with a 17v DC power pack as opposed to AC. I also installed a ELK 950 surge suppressor on the phone line and the dc output of the PSU.
I was told the new...
Hi
Ive recently noticed increase in the background static on my M1 Gold audio when playing system messages etc.
Has anyone noticed this, My system is only using 2 x ELK SP12F flushmount speakers wired in parrallel. My system has been up for about 3 1/2yrs with no real troubles
If i power...
These are imaginary outputs used to prevent visitors pressing the doorbell too many times and also one used for a counter to indicated if I missed visitors while away.
Anthony
Wondering if anyone can give me a work around to the following problem.
I have a doorbell zone connected to the M1 Gold - which i announce a custom recording when pressed.
However whenever the panel is rebooted / powered up the doorbell will chime away for about 10secs.
I understand the panel...
Hi all. Recently got panel damage due to lighting strike. So thought I will install a elk 950 to protect the replacement panel. However the new panel was supplied with a dc power supply. The instructions indicate the surge suppressor can protect ac power pack.
Has anyone connected a dc power...
Hi all
Just noticed the elk website has been updated î•
I've registered a new account on that site as an m1 owner. However I cannot find were all the downloads are for firmware updates / manuals etc.
Any help
Anthony
Hi All
I'm trying to display some text and a counter on the M1 Keypad.
I can succesfully do this while the system is armed..
However i'm trying to get the message to display on the screen once the system is disarmed - but disarming the system is clearing all the messages
Any tips
Anthony
Hi Spanky
I'm quite confident the damaged cap is the problem, i set the zone to NO and with nothing connected to the wire both RP & KP show the zone as violated "short".
I should receive my new KP early in the week. "just a mystery how the cap got damaged"
Anthony
I've just noticed a capacitor on the back of the kp near the wire connector that appears to be damaged / burnt out.
The keypad still works however i suspect this capacitor has something to do with the zone input.
Iv'e ordered a new keypad to replace - fingers crossed that is the problem.
Anthony
I worked it out.
So simply "right click on zones and select add"
However the zone always has a violated state "Short" - ive set to non alarm - normally open.
I've cut the wire of the kp and it still shows a short????
Thanks anyway
Hi All
I've just wired up my doorbell button to the keypad zone input "zone 193".
However i can not work out how to select this zone in the rules - the only zones that show up in RP are the hardwired zones.
What have i missed.
Thanks
Anthony
Can some one highlight how you would wire the led into the zone input on the M1????
I've just purchased a door bell button which i would like to lit up with an led - just not 100% what resistor is required
Anthony
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.