Adding more then 2 speakers to OmniPro II

[pbeaulieu]

Can you add more then 2 speakers to the "Two-way voice Module #10A11-1"?

I would like to add 2 more speakers without having to add a whole house audio system. I can not justify the $$ for a whole house audio system that would cover 4 rooms.

Any help or suggestions would be appreciated.

 

[fabriziojoe]

Paul,
According to the manual "Additional speakers can be connected to each output in series."

Please see the attached document.

Hope this helps.

View attachment 10A11-1_Install.pdf

Can you add more then 2 speakers to the "Two-way voice Module #10A11-1"?

I would like to add 2 more speakers without having to add a whole house audio system. I can not justify the $$ for a whole house audio system that would cover 4 rooms.

Any help or suggestions would be appreciated.

 

[pbeaulieu]

Paul,
According to the manual "Additional speakers can be connected to each output in series."

Please see the attached document.

Hope this helps.

View attachment 3877

Thanks for the info. I obviously missed that in the instructions.

 

[scorp133]

I'm not sure its explicitly stated, but I'm guessing it needs an 8 Ohm load. Wiring two 8 Ohm speakers in series would give it a 16 Ohm load, and wiring two 8 Ohm speakers in parallel would give it a 4 Ohm load. The more speakers in series the less volume you are going to have. So if you want any more than 4 speakers I would maybe look into doing a series-parallel setup.