Announce on Alarm

[in4ni]

what is the proper programming code to make my OPII "say" the tripped zone on alarm so when the system is tripped i dont have to look at my keypad to see what zone was tripped.
 
 
Thank you
 
 

 

[cestor]

If you assign a voice to the zone then it automatically announces it when tripped
if you want to code it in PC Access, you can have
 
When 'front door' NOT READY
THEN SAY FRONT DOOR OPEN

 

[Desert_AIP]

Announce on alarm setting in PCAccess will speak the zone during an alarm event automatically without further programming.
You'll need to add a voice description to each zone.
If you want it to announce tripped zones while in the OFF mode you need to add individual programming and messages for each zone.
You need to add messages, it will not use the voice associated with the zone for this purpose.

 

[in4ni]

I have "announce alarms" set to YES, there are voices setup on the zones and areas however I dont get any voices when the alarm is tripped
 
 
Did i miss anything?
 
 
Thank you