I am looking to control my reef aquarium usung an ELK M1 system. As per my previous post I was looking for an inexpensive controllable powerstip, for pumps, lights...and I think I found a good solution...
http://www.digital-loggers.com/EPC.html I will connect to this device using an ELK M1XSP.
I have a couple of other design challenges, perhaps this group might have some solutions....
1) I need a good temp probe...one that can be used in water (salt water!)
2) It would be nice if I could also monitor the water pH values..there are rules that I could write that would adjust the waters pH values by activating certain pumps to dose the aquarium with the correct buffers...any ideas on how to interface a pH probe to an M1? Perhaps there are pools systems out there that are controlled by an M1. Not a huge deal as there are dedicated pH controllers out there but it would be nice to be able to control other rules that involve pH values. I did find this device..close but I don't think it will work as it is a parallel device...
http://www.drdaq.com/products.html
Thanks in advance!
http://www.digital-loggers.com/EPC.html I will connect to this device using an ELK M1XSP.
I have a couple of other design challenges, perhaps this group might have some solutions....
1) I need a good temp probe...one that can be used in water (salt water!)
2) It would be nice if I could also monitor the water pH values..there are rules that I could write that would adjust the waters pH values by activating certain pumps to dose the aquarium with the correct buffers...any ideas on how to interface a pH probe to an M1? Perhaps there are pools systems out there that are controlled by an M1. Not a huge deal as there are dedicated pH controllers out there but it would be nice to be able to control other rules that involve pH values. I did find this device..close but I don't think it will work as it is a parallel device...
http://www.drdaq.com/products.html
Thanks in advance!