TeleFragger
Active Member
well i dont want to type it all back in here..
summary.. i had 2 brultech 1240s setup via mux connector and a 50'serial port... it was working.. and sat for a bit.. i then just recently figured id get it all setup....
well i went to their site and there is a new firmware.. figured id install it and start there.. 1.026
after i installed the firware on both... i can still click read settings in brultechs IA... and it sees both.. but still with 1.025???
no biggie.. my main issue is that i can only see 1... 1 of them... the data light no longer works... i cant get it to reset, cant reflash, nothing...
more reading here...
help greatly appreciated
http://forums.homeseer.com/showthread.php?t=149724
summary.. i had 2 brultech 1240s setup via mux connector and a 50'serial port... it was working.. and sat for a bit.. i then just recently figured id get it all setup....
well i went to their site and there is a new firmware.. figured id install it and start there.. 1.026
after i installed the firware on both... i can still click read settings in brultechs IA... and it sees both.. but still with 1.025???
no biggie.. my main issue is that i can only see 1... 1 of them... the data light no longer works... i cant get it to reset, cant reflash, nothing...
more reading here...
help greatly appreciated
http://forums.homeseer.com/showthread.php?t=149724