The Brultech CT settings calculator says I need a 25.5 ohm 1% resistor to use with a single micro-CT across the Ch1 or Ch2 "single" channel. Does this one fit the bill? It's 25.5 ohm, 1% tolerance, but I don't know if the other spec's are good enough.
The Brultech CT settings calculator says I need a 25.5 ohm 1% resistor to use with a single micro-CT across the Ch1 or Ch2 "single" channel. Does this one fit the bill? It's 25.5 ohm, 1% tolerance, but I don't know if the other spec's are good enough.
IMHEO (in my humble electrical opinion), you would be fine with that one. Its a 4/10th watt and since I doubt if most applications would produce a voltage across it more than a few milivolts, it doesn't have to dissipate much power.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
), you would be fine with that one. Its a 4/10th watt and since I doubt if most applications would produce a voltage across it more than a few milivolts, it doesn't have to dissipate much power.
