Caddx NX-4 password reset

[nassartm]

Hi All
I have Caddx Nx-4 panel and I am not able to move to programming mode ,the default program code is not accepting .When I enter * 8 9713 all function LEDs are continue flashing .Please let me know how can I reset the programming code back to default . I checked the circuit board and I couldn't find any rest jumper .Please help me if some know the reset procedure

 

[RAL]

Is this a new panel, or one that was previously installed by an alarm company?  Have you tried the 6-digit code of 971300 ?

 

[nassartm]

No it is old panel .I have tried 4 digit and 6 digit format for all known combinations .while I was searching I understand that we can recover the installer code try DL 900 software but it require nx 486 flash programmer.is there anyway to reset through keypad.please let me know

 

[nassartm]

No it is old panel .I have tried 4 digit and 6 digit format for all known combinations .while I was searching I understand that we can recover the installer code thru DL 900 software but it require nx 486 flash programmer.is there any way to reset through keypad.please let me know

 

[RAL]

I'm not an expert on the NX-4, but unless you can find out the master password from the previous owner or alarm company that serviced it, I think you are out of luck.  There's no back door that will reset it back to the default.

 

[Del91574]

Instant Unlocker (now owned by Linear) is the only way I know of without going crazy on it.
 
The panel is a NX-4. Dime a dozen.