After installing the RP software, and the firmware upgrades, I did an initial connection to my ELM M1 Gold via serial port. During this connection I updated the firmware on the main board.
When I tried to reconnect I was unable to. The status light was blinking as it should, I re-enrolled all the keypads.
The message is "Disconnected: System rejected Remote Programming Access Code".
I suspect the problem is, I didn't enter a code at initial connection.
The published default code does not work. The master user code does not work. The installer code does not work.
Any ideas? Tech support wants to RMA my board for a reset. Can I do it myself?
Thanks,
E
When I tried to reconnect I was unable to. The status light was blinking as it should, I re-enrolled all the keypads.
The message is "Disconnected: System rejected Remote Programming Access Code".
I suspect the problem is, I didn't enter a code at initial connection.
The published default code does not work. The master user code does not work. The installer code does not work.
Any ideas? Tech support wants to RMA my board for a reset. Can I do it myself?
Thanks,
E