ctwilliams
Active Member
I finally have become brave enough to tackle adding smoke detectors to the M1. I am using a four wire smoke detector from GE.
The instructions included with it show using the end of line supervised power relay. To make sure I know what I am doing I have just installed one detector with the power relay as shown in the diagram.
When I add it to the M1 it shows Fire Trouble and that there is a short. I searched through the forms and was not able to find this problem specifically. I did find one that seemed to indicate that their should be approx 7 ohms in between the NO and Common terminals and I do have that.
Other than that, I am not sure what I should try next.
Any ideas?
Thanks,
CT
The instructions included with it show using the end of line supervised power relay. To make sure I know what I am doing I have just installed one detector with the power relay as shown in the diagram.
When I add it to the M1 it shows Fire Trouble and that there is a short. I searched through the forms and was not able to find this problem specifically. I did find one that seemed to indicate that their should be approx 7 ohms in between the NO and Common terminals and I do have that.
Other than that, I am not sure what I should try next.
Any ideas?
Thanks,
CT