politics123
Active Member
So --
I thought I bench tested these things. I had them setup as non-alarm, and then tied a rule to the zone (when violated, speak). I dipped a sensor into the water, Elk spoke, I thought all was good.
But now that I'm actually ready to roll them out and configure these to be Water Alarm zones, I can't seem to get the ELK setup correct for these water sensors. They are supposed to be "Normally Open" and I've tried configuring the zone that way. However, the Elk claims that there is a zone trouble. When I bring up the Status page in ElkRP, it indicates the state being EOLR and the volts being 8.1.
Any ideas?
mh
I thought I bench tested these things. I had them setup as non-alarm, and then tied a rule to the zone (when violated, speak). I dipped a sensor into the water, Elk spoke, I thought all was good.
But now that I'm actually ready to roll them out and configure these to be Water Alarm zones, I can't seem to get the ELK setup correct for these water sensors. They are supposed to be "Normally Open" and I've tried configuring the zone that way. However, the Elk claims that there is a zone trouble. When I bring up the Status page in ElkRP, it indicates the state being EOLR and the volts being 8.1.
Any ideas?
mh