I've just moved into a new home and installed my HAI Omni Pro II system from my previous residence. Previously i only used x10, but in the new home I have the following configuration:
UPB - lighting control (lamp modules currently - haven't had time to install light switches)
zwave - thermostats and schlage door locks
x10 - christmas lighting (lamp modules)
The Omni system turns the lighting on at the programmed times correctly via the PIM's. Now when the Omni system sends an "all-off" command (through programming or through the keypad) the light status' within the Omni Pro change to off, but the lighting is still on. I can still turn them off one at a time through the keypad or my Snap-link iPhone app. Any idea why the all off command isn't working anymore? Is there a programming option in the Omni Pro II that i missed setting up for UPB?
I've also noticed that issuing a "lock all doors" command through programming doesn't seem to work - but if I address them one at a time they lock/unlock correctly.
UPB - lighting control (lamp modules currently - haven't had time to install light switches)
zwave - thermostats and schlage door locks
x10 - christmas lighting (lamp modules)
The Omni system turns the lighting on at the programmed times correctly via the PIM's. Now when the Omni system sends an "all-off" command (through programming or through the keypad) the light status' within the Omni Pro change to off, but the lighting is still on. I can still turn them off one at a time through the keypad or my Snap-link iPhone app. Any idea why the all off command isn't working anymore? Is there a programming option in the Omni Pro II that i missed setting up for UPB?
I've also noticed that issuing a "lock all doors" command through programming doesn't seem to work - but if I address them one at a time they lock/unlock correctly.