knowinnothin
New Member
Hello everyone,
I'm currently trying to integrate a HVAC system with a Omni Pro system. For the main floor of the house I've got a RC-1000 to control heat/cool, for the lower level I'm using a RC-2000 to control a separate furnace for heat/cool as well as a electric boiler for in-floor heat.
Now the main floor is easy, I'm using a 30A00 "TPSM" with the RC-1000 because it is a 4 wire system.
However for the lower level I Need to isolate the electric boiler from the furnace, I also need the electric boiler to be W1 (2 wire).
Would the 29A00 thermostat isolation module be the appropriate interface for this system, looking at the wiring instructions it doesn't seem like it?
Im stumped right now how I'm going to accomplish this, my distributor has been less than helpful during this installation.
Any help or suggestions would be greatly appreciated.
Thanks
I'm currently trying to integrate a HVAC system with a Omni Pro system. For the main floor of the house I've got a RC-1000 to control heat/cool, for the lower level I'm using a RC-2000 to control a separate furnace for heat/cool as well as a electric boiler for in-floor heat.
Now the main floor is easy, I'm using a 30A00 "TPSM" with the RC-1000 because it is a 4 wire system.
However for the lower level I Need to isolate the electric boiler from the furnace, I also need the electric boiler to be W1 (2 wire).
Would the 29A00 thermostat isolation module be the appropriate interface for this system, looking at the wiring instructions it doesn't seem like it?
Im stumped right now how I'm going to accomplish this, my distributor has been less than helpful during this installation.
Any help or suggestions would be greatly appreciated.
Thanks
