sonflowerinwales
New Member
Hi there
Bought my Hobby Boards hardware just before Christmas. All installed and after a slow start, got Arne's software working. Really should read the instructions!
I have two problems.
1) The humidity sensor is reading 100%, all the time. I've tried parasitic power and external supply (19v). Neither seem to work, jumper on and jumper off. I restart the software every time.
2) The barometer temperature is always much higher than the DS18S20 temperature in the same location Within 2". (See Barometer temperature vs Inside Module at http://weather.no-ip.info/weather.html)
Can anyone help please?
The hardware is running W2000 and Henriksen software, serial port connector DS9097U, independent DC power supply, located in an airy shed, there are two extra DS18S20's, AAG Weather station, barometer, humidity, lightning and rain gauge, all the sensors daisy chained. The results can be seen at http://weather.no-ip.info/weather.html.
Hope someone can help?
Paul
Bought my Hobby Boards hardware just before Christmas. All installed and after a slow start, got Arne's software working. Really should read the instructions!
I have two problems.
1) The humidity sensor is reading 100%, all the time. I've tried parasitic power and external supply (19v). Neither seem to work, jumper on and jumper off. I restart the software every time.
2) The barometer temperature is always much higher than the DS18S20 temperature in the same location Within 2". (See Barometer temperature vs Inside Module at http://weather.no-ip.info/weather.html)
Can anyone help please?
The hardware is running W2000 and Henriksen software, serial port connector DS9097U, independent DC power supply, located in an airy shed, there are two extra DS18S20's, AAG Weather station, barometer, humidity, lightning and rain gauge, all the sensors daisy chained. The results can be seen at http://weather.no-ip.info/weather.html.
Hope someone can help?
Paul