Intermittent 3 Beeps on Phone - OmniPro 11

[bonster]

Hi,
 
I have had an OminProII installed and when ever I use the phone for normal calls about every three minutes or so the phone will beep three times. I read in the manual how OmniPro security connects to the line on any call to check for # key but then disconnects. This sounds like the security system jumping onto the phone line but does not align with anything I have read.
 
Any ideas where I should look to best try and remove this annoying problem.
 
Thanks in anticipation.
 
Peter

 

[Desert_AIP]

Disconnect the Omni and see if it still happens
 
My guess is it won't.
I've only ever heard a single beep from the Omni when it first picks up the line.
 
Also if you have an answering machine or fax, you need to set the rings on each device and the Omni so they don't conflict.
 
Do you have telephone company voice mail?

 

[bonster]

I disconnected the Omni and it did not happen. I reconnected the Omni again and  it also did not happen. So it seems at this stage that a re-set of the connection appears to have fixed the problem......at least I hope so. Thanks for taking the time to respond.

 

[bonster]

The beeps are back so the reesetting of the connection did not seem to do the trick. As I have an answering machine based on the above response "I need to reset the rings on the each device and the Omni so they don't conflict", now might I go about doing that ? 
 
Peter

 

[Desert_AIP]

I set the rings on my answering machine to Toll Saver (2 or 4 depending on if there are messages) so I set the Omni to 8 rings.
So the answering machine will always pick up the phone.
 
If I need to call the Omni I call in let it ring once, then hang up and call back within one minute.
The Omni will immediately pick up the line and I can enter my code.