tmbrown97
Senior Member
I'm not sure of my options for entering the next wall cavity on either side - I'll have to look. One can is directly above the other - only inches between them (the 20" was existing; I added the 50" above it - well, because I could) - and figured I'd leave the ugly stuff in the 20" can with the solid door (like all the power adapters, UPB CIM, Battery, ETC) and keep the 50" can looking as nice as possible since I sprung for the plexi door. For now I kept the battery directly below the panel as recommended, but I'd like to double the battery size and move it if it makes sense to do so.
My expectation was to use an inline automotive blade fuse holder and put the fuse as close to the battery as possible; I'd also go up a gauge in wire size for good measure (the total run would ube under 5ft)... I've also seen/used the self resetting circuit breakers that'll fit a standard blade fuse pattern - that would seem safer for the self-resetting factor - would it help with the legality? Thx guys.
My expectation was to use an inline automotive blade fuse holder and put the fuse as close to the battery as possible; I'd also go up a gauge in wire size for good measure (the total run would ube under 5ft)... I've also seen/used the self resetting circuit breakers that'll fit a standard blade fuse pattern - that would seem safer for the self-resetting factor - would it help with the legality? Thx guys.